Raspberry Pi 3 - case

This is a design to 3d print a Raspberry Pi 3 case.
This **IS NOT** compatible with any previous versions (Raspberry Pi 2 or older)

* This case comprises of a top and bottom half connected by screws.
* Your Raspberry Pi 3 has to be connected to the bottom half by screws.
* Additional mount holes are present on bottom half if you prefer to attach the whole case to a VESA compliant mount.
* Case exposes all the major pi ports: power, audio, hdmi, Lan, 4 USB ports, memory card.
* The GPIO pins are not exposed by default BUT there is a perforated tab here - so if you need GPIO ports too, just pressing down with a flat screwdriver over the dotted tabs.
* Case supports regular size heat sink.
* *Case does not support fan.*

#####Screws needed:
Four M3 x 6mm sheet metal screws - to attach pi to the case.
Four #4 x 3/4" sheet metal screws Alternative: M3 x 18mm - to attach both cases together.
Four 75mm VESA **