Raspberry PI 4b Case

Case for my RetroPie living room setup. The case can fit a 40mm fan with room for heat sinks if you prefer.

The radii around the top and bottom of the case ended up looking like chamfers on my print. You may want to use supports on yours. Also, the chamfers around the mesh holes didn't turn out as well.

I modified the recesses for the 2 micro HDMI and USB C from my print. Instead of being separated by a wall, they are all one recess. I couldn't get the end of my micro HDMI to fit properly, so that is why I made the change.

I did a filament change command at the end of the top and bottom edge radii to make this ice cream sandwich kind of look.

Printed on Anycubic i3 Mega using Cura

List of Hardware:

40mm Noctua 5V fan
https://www.amazon.com/gp/product/B00NEMGCIA/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1

M2.5 x 25mm SHCS x 4

M2.5 nut x 4

M4 x 16mm BHCS x 4

M4 nut x 4

Clear rubber feet x 4
https://www.amazon.com/gp/product/B088BP8ZHM/ref=ppx_yo_dt