Thingiverse
Raspberry Pi Camera Flat Mount
by Matchstic
4
Downloads
0
Likes
0
Makes
This is a small mounting kit for the Raspberry Pi camera.
I used an M2.5 nylon screw and nut to secure the hinge, but you may also be able to get away with an M3 screw instead.
The back is supposed to be push-fit, though the tolerances may be slightly too great - I ended up needing to use a small amount of tape to hold it on!
Full disclosure: this is a remix, but I honestly cannot remember where I sourced the original design. Sorry. :(
I used an M2.5 nylon screw and nut to secure the hinge, but you may also be able to get away with an M3 screw instead.
The back is supposed to be push-fit, though the tolerances may be slightly too great - I ended up needing to use a small amount of tape to hold it on!
Full disclosure: this is a remix, but I honestly cannot remember where I sourced the original design. Sorry. :(
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
![Raspberry pi cam v2 (adjustable focus) mount [Octoprint friendly]](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Fassets%2F74%2Fe8%2F70%2Fcc%2F2a%2Flarge_display_Pi4_mount_New_supports.png&w=400&h=300)