Thingiverse
Raspberry Pi Camera Mount ender3 Pro
von MellowDuck
37
Downloads
15
Likes
1
Makes
This is a Remix of https://www.thingiverse.com/thing:4350729
I made this remix to fit an Ender 3 pro, original design was for a regular Ender3. I extended the clip of the mounting area and also made room for the Y motor belt to run without interruption. I also used the same idea at the original by including supports on the modified section that should remove easily once printed.
Pictures are from an early test print.
I made this remix to fit an Ender 3 pro, original design was for a regular Ender3. I extended the clip of the mounting area and also made room for the Y motor belt to run without interruption. I also used the same idea at the original by including supports on the modified section that should remove easily once printed.
Pictures are from an early test print.
MellowDuck veröffentlicht auch auf
25 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
