Thingiverse
Raspberry Pi Camera Mount for 3D printer
von Adcade
8
Downloads
7
Likes
1
Makes
This is a mount and case for the Raspberry Pi Camera module, to be mounted on a Voron V2 or any other 3D printer.
It allows mounting the camera flush with the ceiling of the printer, and have a top view from the front without horizontal angle (like when you mount it on a corner). I designed this because I wanted a camera inside the chamber, and I didn't want it on the way of the carriages. As shown in one of the pictures, it has just the right clearance when the extruder is at Z220 (max height for my Voron 2.4 250mm).
To mount it, you will need:
- 2x M3x8 mm bolts
- 2x M3 T-nuts
- 4x M2x6 self tapping screws (I used M2x10 and cut the tip)
It allows mounting the camera flush with the ceiling of the printer, and have a top view from the front without horizontal angle (like when you mount it on a corner). I designed this because I wanted a camera inside the chamber, and I didn't want it on the way of the carriages. As shown in one of the pictures, it has just the right clearance when the extruder is at Z220 (max height for my Voron 2.4 250mm).
To mount it, you will need:
- 2x M3x8 mm bolts
- 2x M3 T-nuts
- 4x M2x6 self tapping screws (I used M2x10 and cut the tip)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
