Thingiverse
Raspberry Pi Case
door alessandrovalli
8
Downloads
12
Likes
1
Makes
Just a variation of the thing with a few *ports covered* and different airflow. VESA 75mm holes. A hole for a camera lens, too. This is my first attempt at modeling for 3D printing. All comments and suggestions are welcome.
4x M2 x 4mm self-tapping to mount the optical sensor (untested)
4x M2.5 x 6mm self-tapping to mount the main PCB (untested)
4x M3 x 30mm + locknuts to close the case (tamper-resistant: Torx?)
4x M2 x 4mm self-tapping to mount the optical sensor (untested)
4x M2.5 x 6mm self-tapping to mount the main PCB (untested)
4x M3 x 30mm + locknuts to close the case (tamper-resistant: Torx?)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!