Thingiverse
Raspberry Pi Cluster Stand
von SnarkyJosh
60
Downloads
32
Likes
1
Makes
I'm building a Raspberry Pi 4b cluster and needed something to mount my case and switch to in order to move them around together and not add strain on the connections.
The case I'm using is the "Yahboom Raspberry Pi Cluster Case".
The switch I'm using is the "TP-Link 5 Port Fast Ethernet 10/100Mbps PoE Switch"
I used M3-.50 x 8 screws to mount the case to the stand.
My printer is dialed in pretty good so the switch is held in snug and doesn't fall out if I tip it upside down.
Update 2/22/2021 (v2)
Added an extra cutout below the switch in order to route the main network cable from the back to the connection on the front.
The case I'm using is the "Yahboom Raspberry Pi Cluster Case".
The switch I'm using is the "TP-Link 5 Port Fast Ethernet 10/100Mbps PoE Switch"
I used M3-.50 x 8 screws to mount the case to the stand.
My printer is dialed in pretty good so the switch is held in snug and doesn't fall out if I tip it upside down.
Update 2/22/2021 (v2)
Added an extra cutout below the switch in order to route the main network cable from the back to the connection on the front.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
