Slicer Discord
Raspberry Pi HQ Camera Slip Case – 3D printable model from Thingiverse Thingiverse

Raspberry Pi HQ Camera Slip Case

17 Downloads
16 Likes
0 Makes
Go to Model
This is a cover for the circuit board of a Raspberry Pi HQ camera. It slips over the top, leaving the bottom open for the ribbon cable and the front clear for the lens mount.

It is a friction fit, the screw holes in the circuit board are not used.

[Source file on Tinkercad](https://www.tinkercad.com/things/e6scczI5Ta3)

*Update*: See the comment #marcluer, and be aware of potential interference with some components on the PC board. With my measurements and printer's tolerances, this was not an issue for me, but your mileage may vary.

Be careful.
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Polycarbonate
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection