Thingiverse
Raspberry Pi Model 3B Case
door AwZamo
14
Downloads
11
Likes
0
Makes
I wanted a case that fit my Pi. The one I ordered was off a bit so I set to modeling it using Fusion 360.
I left the top a "blank" to allow for remixing - adding your own cut outs or logos.
The top and bottom were printed on the flat sides. The middle was printed with the slots for the top on the bottom (and with supports .
Minor clean up is necessary to align the slots for the top to fit as the initial layer was 125% wider.
*Printed on the Mini 1.03
I left the top a "blank" to allow for remixing - adding your own cut outs or logos.
The top and bottom were printed on the flat sides. The middle was printed with the slots for the top on the bottom (and with supports .
Minor clean up is necessary to align the slots for the top to fit as the initial layer was 125% wider.
*Printed on the Mini 1.03
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!