Thingiverse
Raspberry Pi Stacking Tray
von JohnnyFive
77
Downloads
50
Likes
0
Makes
I have seen other stacking trays for the Raspberry Pi and liked the idea. I designed this tray differently so that I would have easy access to the micro SD card and better access to the GPIO pins. Also I made the base layer of the tray thicker so that it didn't feel as flimsy.
Minimal or no post-processing should be needed. However if you print in ABS the droop/sag of the first layers might require the holes to be opened up a bit.
I have included the SLDPRT if you want to modify this design or export the STL with lower resolution.
Minimal or no post-processing should be needed. However if you print in ABS the droop/sag of the first layers might require the holes to be opened up a bit.
I have included the SLDPRT if you want to modify this design or export the STL with lower resolution.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
