Thingiverse
Raspberry Pi Zero Case
door stampydriver
15
Downloads
6
Likes
0
Makes
Simple Raspberry PI Zero case. All of these cases I could find were too flimsy for my needs. I wanted a tougher case that also supported access to the GPIO headers. This case is built with thicker walls and feels much tougher.
Printed in PLA with 100% infill. The board needs to be screwed in place with 2mm x 4mm (long) self tapping screws. The lid just snaps on.
There are no logos or graphics on this case. It's purely a case. Not an advertisement :)
Printed in PLA with 100% infill. The board needs to be screwed in place with 2mm x 4mm (long) self tapping screws. The lid just snaps on.
There are no logos or graphics on this case. It's purely a case. Not an advertisement :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
