Thingiverse
Raspberry Pi Zero MiniAmp Case
von marcnetic
5
Downloads
4
Likes
1
Makes
This is the case for one of my Snapcast clients. It houses a Raspberry Pi Zero W and a HiFiBerry MiniAmp. The Raspberry Pi Zero 2 W has the same footprint and will also fit. I only need the PWR IN micro USB, but I have added versions of the bottom part that expose the other connectors.
### Print
* No supports required
* Print lid upside down
### Installation
Insert the Pi with the connectors first from diagonally above and let the rear part fall into place. Then attach the MiniAmp with the GPIO headers. There is no need for spacers, because the front part of the MiniAmp is supported by the housing.
* No supports required
* Print lid upside down
### Installation
Insert the Pi with the connectors first from diagonally above and let the rear part fall into place. Then attach the MiniAmp with the GPIO headers. There is no need for spacers, because the front part of the MiniAmp is supported by the housing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
