Thingiverse
Raspberry Pi Zero Node
von blankdesign
990
Downloads
732
Likes
1
Makes
This is my first iteration of the Raspberry pi zero Node and I expect to make some changes based on community feedback. The Idea was to make an enclosure for a raspberry pi zero that runs of of a single 18650 that can be charged in the case.
I also designed a small shelf in the enclosure to hold a piece of RGB led strip with the intent to use the led as a programmable indicator light, though I have yet to install the LED.
If you have any suggestions for ways I can Improve this design or any better components I could use for the charging board please leave a comment.
Have Fun!
I also designed a small shelf in the enclosure to hold a piece of RGB led strip with the intent to use the led as a programmable indicator light, though I have yet to install the LED.
If you have any suggestions for ways I can Improve this design or any better components I could use for the charging board please leave a comment.
Have Fun!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
