Thingiverse
Raspberry Pi Zero Simple Open Case
par noisycarlos
6
Téléchargements
4
Likes
0
Makes
I needed a quick and simple holder for the Raspberry Pi Zero (and Zero W) while I was designing a prototype.
I needed access to the GPIO pins to move it around, so I made it an open case with the port slots open (so you can remove it from the case while plugged in).
It prints in 10-20 minutes, and the Pi Zero board should just snap in.
I needed access to the GPIO pins to move it around, so I made it an open case with the port slots open (so you can remove it from the case while plugged in).
It prints in 10-20 minutes, and the Pi Zero board should just snap in.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !