Thingiverse
Electronics
Zum Modell
Raspberry Pi Zero W case
69
Downloads
41
Likes
0
Makes
Remix of Iakouben's Raspberry Pi Zero W case (https://www.thingiverse.com/thing:2349678) to suit the Ender 3.
I figured the rear of the machine was the best compromise as there was plenty of space and any cables would be out of the way of the Y axis rollers.
From my original print I enlarged the holes a little on the case, however you may need to grab a 3.5mm drill bit and clean them up. Otherwise the screws from the Ender 3 should just bite into the plastic.
I figured the rear of the machine was the best compromise as there was plenty of space and any cables would be out of the way of the Y axis rollers.
From my original print I enlarged the holes a little on the case, however you may need to grab a 3.5mm drill bit and clean them up. Otherwise the screws from the Ender 3 should just bite into the plastic.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
