Thingiverse
Raspberry Pi Zero W Case
von tulkaris
0
Downloads
1
Likes
0
Makes
This a remix to replace the PiCam with a night vision camera with circular lens.
Printed on my old Anet A8 with 30% infill, 0.28 layer, without any supports.
After printing, with a slight pressure the hinge is released and the piece is fully functional.
Printed on my old Anet A8 with 30% infill, 0.28 layer, without any supports.
After printing, with a slight pressure the hinge is released and the piece is fully functional.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
