RB2 Tilted LCD Front Covers

This is a tilted LCD display case and accompanying name panel for the Rigidbot 2 (RB2).

Now those that have RB2's without LCD's can have a way to install a stock one and those that already have one can now view it easier. These parts will replace either original panel configuration.

There is a minimal amount of post processing required on the upper tabs of the tilted LCD case to allow printing without support material. See post processing below.

Pop the name plate in top edge first and then the LCD case the same way. You may have to push up on the name plate tabs to get them started and then they pop in place. Pushing up on the bottom face of the tilted LCD case will pop it in place. By reaching inside and pushing up on the bottom tabs you can remove both panels.

----------

part #2091

----------

As with all our printer parts these are precision parts. For best results it is highly recommended that you use calibrated filament using the method found here: https://www