Thingiverse
RC - Controller Enclosure
door mixikaabin
1
Downloads
0
Likes
0
Makes
This enclosure is for my 4x4 RC controller, to hopefully make it more resistant against water.
The bolt locations are more or less specific for my frankenstein RC, but if somebody can use it, well now they can.
Beware that this is a version 1, untested design. As it something I would like to printe for my RC car, I'll find some improvements at somepoint. But I you try this design I would like the feedback.
I'll print it tomorrow as it late where I am. It will be printet on a Wanhao Duplicator D7 resin printer.
I have include two version, one with M4 threads and one without threads.
To generate the threads I am using this openscad library: http://dkprojects.net/openscad-threads/ from Dan Kirshner.
The bolt locations are more or less specific for my frankenstein RC, but if somebody can use it, well now they can.
Beware that this is a version 1, untested design. As it something I would like to printe for my RC car, I'll find some improvements at somepoint. But I you try this design I would like the feedback.
I'll print it tomorrow as it late where I am. It will be printet on a Wanhao Duplicator D7 resin printer.
I have include two version, one with M4 threads and one without threads.
To generate the threads I am using this openscad library: http://dkprojects.net/openscad-threads/ from Dan Kirshner.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
