RDQ 182 Pod

This is a little pod design that I worked on with a buddy for the RDQ 182 frame. It mounts right on top of the stack, has countersunk nut positions for the rear mounts, includes countersunk nut position for a standard antenna whip to mount through, and can hold a gopro. The pod is meant to be mounted on a stack no higher than 20mm.

I print this upside down and with the gopro seat parallel to the build surface. Requires supports. The version pictured was printed in TPU at 100% infill. I felt that this gave it the stiffness necessary to hold the cameras solid yet the flexibility to take an impact and not shatter or separate layers. The supports were a little tricky to remove without destroying anything so be careful there.

This still has a few tweaks I'd like to make but here is the current version which should be more than capable of printing and building with.

Good luck and enjoy!