Thingiverse
Red Ring Box
von NHakim124
7
Downloads
3
Likes
0
Makes
This is the box/container to put your Red Lantern Ring from my previous design...
NOTE: The box itself wouldn't need any supports but for the LID it is highly recommended that you use supports (touching buildplate), if not there may be a high risk of it caving in while printing.
NOTE: The box itself wouldn't need any supports but for the LID it is highly recommended that you use supports (touching buildplate), if not there may be a high risk of it caving in while printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!