GrabCAD
Fusion 360
Model downloaden
Remote Controller
74
Downloads
8
Likes
0
Makes
A remote controller case with two joysticks. Each Joystick has two holes for trimming with a Poti, a master On/Off switch is integrated in the middle, And a display (e.g. ST7735) in the bottom. The display is surrounded by six holes for Buttons In the front, there is another hole for an antenna. Inside, there are supports for an arduino due and two 9V block Batteries
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
