Thingiverse

Replicator 2 Active Cooling Fan Mount w/Threaded Inserts

von makerbotman

18 Downloads

6 Likes

1 Makes

Remix of a great remix, but my screws did not bite into the holes, so I added McMaster Carr metal inserts for serviceability.

Use McMaster 94180A333 Heat-Set Inserts for Plastics M3 x 0.5 mm Thread Size, 6.4 mm Installed Length. https://www.mcmaster.com/#94180a333

Press them in as far as you can go, then give it a little soldering iron heat to melt them into place.

active cooling mount active cooling fan fan brace Fan mount makerbot Makerbot Replicator 2 makerbot upgrade part replicator part replicator2 parts replicator 2 replicator upgrade active cooling mount active cooling fan fan brace Fan mount makerbot Makerbot Replicator 2 makerbot upgrade part replicator part replicator2 parts replicator 2 replicator upgrade active cooling mount active cooling fan fan brace Fan mount makerbot Makerbot Replicator 2 makerbot upgrade part replicator part replicator2 parts replicator 2 replicator upgrade

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat