Thingiverse
Replicator 2 (lockable) Case
door fumalcon
36
Downloads
25
Likes
0
Makes
This case was designed to be a locked enclosure for the Replicator 2.
Parts you will need.
1/4" acrylic (will need four(4) 24"x18" sheets to cut out all 6 pieces)
- piece dimensions --
front panel: outer - 15"x11", inner - 14.5"x10.5"
side panels(2): 16.25"x11.75"
back panel: 20"x8"
top panel: 20"x16"
Cam Locks(4) - 1561A24 McMaster
Side Mount Hardware: (8) 91290A320 McMaster
Back Mount Hardware: screw(4) 91290A330 McMaster
nuts(4) 90685A043 McMaster
The top panel also has two bends that need to be made after the acrylic is cut.
Parts you will need.
1/4" acrylic (will need four(4) 24"x18" sheets to cut out all 6 pieces)
- piece dimensions --
front panel: outer - 15"x11", inner - 14.5"x10.5"
side panels(2): 16.25"x11.75"
back panel: 20"x8"
top panel: 20"x16"
Cam Locks(4) - 1561A24 McMaster
Side Mount Hardware: (8) 91290A320 McMaster
Back Mount Hardware: screw(4) 91290A330 McMaster
nuts(4) 90685A043 McMaster
The top panel also has two bends that need to be made after the acrylic is cut.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
