Thingiverse
ResizerBot - Parametric MakerBot-Setup
por hotkey
6
Descargas
8
Likes
0
Makes
I was thinking about the optimal stage set up for the MakerBot to increase the maximum buildable area. This is the outcome:
My idea: Creating the whole stage from one big extruded/casted (aluminum?) piece, just adding a motor, a belt and rails. If that actually works, what about using the same pieces for all three stages? Wouldn't that be awesome? It could be quite precise and very, very cheap to produce!
What do you think?
Best of all: This design is size independent - the base, belts and rails can be produced at arbitrary lengths! So give it a try with a 10m stage!
Allow me to dream away for a while... :-)
My idea: Creating the whole stage from one big extruded/casted (aluminum?) piece, just adding a motor, a belt and rails. If that actually works, what about using the same pieces for all three stages? Wouldn't that be awesome? It could be quite precise and very, very cheap to produce!
What do you think?
Best of all: This design is size independent - the base, belts and rails can be produced at arbitrary lengths! So give it a try with a 10m stage!
Allow me to dream away for a while... :-)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
