Retrograde Clock 2

I present to you the Retrograde Clock Model 2 https://youtu.be/pmwAHLIBeQYHow to assemble this clock https://youtu.be/rlE-YRmBD0I---Parts required:- 12888 clock movement with 4.5 mm length threaded shaft (WHITE SHAFT with 4.98mm dia. hour shaft/3.12mm dia. minute shaft) with rubber washer, flat washer and nut for mounting.[Sample](https://www.aliexpress.com/item/4000266900072.html?spm=a2g0o.9042311.0.0.845b4c4dL1xttK)- 2 pcs - 19 mm x 2 mm dia. round rod (brass or stainless steel). Ends should be free of burrs and chamfered to allow for easy insertion.Tools required:- 2 mm drill bit- A reamer made with a ~50mm length of 2mm round rod with tip cut diagonally. Leave burrs and sharp edges as is.- 3mm drill bit to remove the burrs on the holes.- Pin vise for the drill bit and reamer. (included)- Wrench to tighten the clock nut. (3d printable wrench included)---Biggest piece is the Chassis / Face: around 210mm x 150mmFor those with smaller build plate, a split Chassis/Face can be printed on a 150mm x 150mm print bed. The split pieces can be aligned using a pair of short (~5mm) piece of 1.75mm filament alignment pins. They can then be glued using CA glue.**PLEASE READ:**© 2022 

When you download the files, you are allowed to print the design for your PERSONAL USE ONLY.**If you would like to sell physical prints**, please subscribe for a monthly renewable commercial license on my patreon - www.patreon.com/boksbox Even with a license to print, I still retain the copyright to the models and design.