MakerWorld
Electronics
Zum Modell
Ring Camera Riser
14
Downloads
2
Likes
14
Makes
This Ring camera riser lifts the camera up 8cm allowing it to see over window frames and other obstacles. I tried to make this as discreate and unnoticeable as possible, it blends quite well into a white kitchen. The inserting the camera into the holder provides enough clamping force to keep the camera and riser attached even if they are knocked over. The wide, square base also makes this rather hard to do.Can be printed for 77.5g at 15% infill, though this can be lowered up to 45g at 5% infill. Hope someone else can find this useful, for any questions feel free to leave a comment.Boost MeThanks :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
