Thingiverse
RocketBook beacon
door RenanLikeLenin
7
Downloads
7
Likes
1
Makes
3D printed Rocketbook beacons.
Print this in red or orange!!! You will probably need to use a pretty low speed since the letters are kind of small.
Orange will be more similar to the real robketbook beacons, but I don't think it matters. I will update later if printing these in red works or not.
Then slap a magnet on its back with some glue (I used sticky tack because I'm on a low budget)
If you found this useful, please donate what you think it is worth to my paypal, [email protected]. Help cover the time of design. (plus these babies cost $15 each normally)
Thanks, Enjoy!
Print this in red or orange!!! You will probably need to use a pretty low speed since the letters are kind of small.
Orange will be more similar to the real robketbook beacons, but I don't think it matters. I will update later if printing these in red works or not.
Then slap a magnet on its back with some glue (I used sticky tack because I'm on a low budget)
If you found this useful, please donate what you think it is worth to my paypal, [email protected]. Help cover the time of design. (plus these babies cost $15 each normally)
Thanks, Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
