Thingiverse
Roll Holder
von imarioo
1
Downloads
1
Likes
0
Makes
This is a holder for rolls of poop Bags.
Take stem 1, put it inside the roll, and make Stem 2 interlock with it from the other side. This way rolls can be changed easily.
The diameter of the stem is 1.5cm and 2.5cm at the ball end, the stem is 25cm long(excluding the heads)
HOW TO PRINT
Print 2 of the "walls" and one of each stem.
Print stems vertically(Ball side down) and a slower speed than usual to ensure part doesn't get knocked over, 40mm/s worked for me
Print with raft for added support
Take stem 1, put it inside the roll, and make Stem 2 interlock with it from the other side. This way rolls can be changed easily.
The diameter of the stem is 1.5cm and 2.5cm at the ball end, the stem is 25cm long(excluding the heads)
HOW TO PRINT
Print 2 of the "walls" and one of each stem.
Print stems vertically(Ball side down) and a slower speed than usual to ensure part doesn't get knocked over, 40mm/s worked for me
Print with raft for added support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
