Rotating Display Table

Rotating Display Stand This is an easy to print and assemble USB C powered turntable model.Whole is only 4cm high❗️ Printing guide 📖 Print all parts from any material in any color you want. I printed everything from black PETG. Use supports for the main body and bottom.2 or 3 walls and infiil 5 - 15% is enough. Non-printed parts you need: N20 motor with a angular gear 3mm diameter shaft. - I used a 13 rpmThe mount is for a 33mm long motor.10x15 push button switchUSB C socket - 2 pin3x1 neodymium magnets - 8pcsM3 screws and nuts - 2pcs After printing all the parts, proceed as follows ⬇️ Place the switch and USB socket into the housing by pressing them in ⬇️ Place the motor in the printed mount ⬇️ Glue the magnets into the holes.Screw the motor to the main body with two M3 screws.Connect black wires together.The red (+) wire from the USB port to the switch. On the other side of the switch connect the red wire from the motor ⬇️Close the lid and connect the USB-C cable.<img class="image_r