Thingiverse
Rotational switch
por terrortoost
0
Descargas
0
Likes
0
Makes
I build this switch for an model engine ignition.
The shaft is designed for a skateboard bearing.
For the shaft you need a 5x5x5mm neodymium magnet ,two 4.5mm bbs as counterweight and an m3 hex screw.
For the switch I used a raizorbalde, and a strong neodymium magnet and some copper wire.
I glued everything in place with some jb weld.
The shaft is designed for a skateboard bearing.
For the shaft you need a 5x5x5mm neodymium magnet ,two 4.5mm bbs as counterweight and an m3 hex screw.
For the switch I used a raizorbalde, and a strong neodymium magnet and some copper wire.
I glued everything in place with some jb weld.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
