Thingiverse
Rotational switch
von terrortoost
0
Downloads
0
Likes
0
Makes
I build this switch for an model engine ignition.
The shaft is designed for a skateboard bearing.
For the shaft you need a 5x5x5mm neodymium magnet ,two 4.5mm bbs as counterweight and an m3 hex screw.
For the switch I used a raizorbalde, and a strong neodymium magnet and some copper wire.
I glued everything in place with some jb weld.
The shaft is designed for a skateboard bearing.
For the shaft you need a 5x5x5mm neodymium magnet ,two 4.5mm bbs as counterweight and an m3 hex screw.
For the switch I used a raizorbalde, and a strong neodymium magnet and some copper wire.
I glued everything in place with some jb weld.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!