Round - Chamfer Corner Generator

Generate your own set of corner round overs - any size and and thickness. a) First you must select the Pad Width - Jig Widthb) Second select the thickness and fix them. Do not change them.Once you know the Body dimensions, and fixed these dimensions, proceed to change the other parts. Then, you can start customizing your Chamfers and Round Corners.The Round Corners and Chamfers are less (½ (half) - the width of the Body or jig). Also, the The parts dont need any screws, and are changeable as long as (a) and (b) are the same.There is a 1mm chamfer on all the edges and this is to avoid the router bit entry/exit on the jig.The jig is also reversible, and can be used with top or bottom guide bearings router bits, so you can use it with a router table or hand held.The jig parts fit with a 0.15 tolerance, and as long as you have enough pressure, you will not have any play in the parts. Last, you can also select the finger holding slot size. Once you have decided and modeled your router jig d