Round table

I designed this for a friend and their bigger printer. So your first job is to scale everything the same scale for the size you wish.Make a note of the scale you are happy with. Apply it to each part. 1x table top1x stem4x feet 12x dowels for the top8x rods for the feet glue hammers and arghhhhh : read on Now the important bit : Because all printers have tolerance differences, I have not scaled down the dowels and rods. However if you just print them, you will need a serious hammer to whack them in and probably damage them, getting them seriously stuck. So when you print them, scale them down by 1%, print one, see if it fits nicely without too much force. Adjust that scale as required to get the tolerance you need. Add glue when fitting.