Thingiverse
Ruby HallO Bed Leveling Probe
door TheUnderDog
4
Downloads
2
Likes
0
Makes
Found a great guide by 626Pilot.
Unfortunately I have a 2020 Ultimaker 2 on a Smothieware board.
I couldn't use 626Pilot's fork of the smoothieware firmaware, but still I used the Delta Grid Compensation from the edge firmware.
The probe support is made to fit the E3Dv6.
It has a Ruby tip and has only the magnet that came with the sensor due to the fact that its not permanent and it doesn't need to retract.
Unfortunately I have a 2020 Ultimaker 2 on a Smothieware board.
I couldn't use 626Pilot's fork of the smoothieware firmaware, but still I used the Delta Grid Compensation from the edge firmware.
The probe support is made to fit the E3Dv6.
It has a Ruby tip and has only the magnet that came with the sensor due to the fact that its not permanent and it doesn't need to retract.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!