Thingiverse
SD Card Capsule - Threaded
door Hoppa_
36
Downloads
28
Likes
0
Makes
An enclosure to keep your SD cards safe from being lost, or damaged by the elements.
Fits 13 SD cards comfortably, not too loose, not too tight.
Fitment may differ depending on print setting and printer capabilities.
V2 has less thread, so about 4 twists compared to 8 twists to remove lid. Thread pitch hadn't changed though. (I haven't tested this yet)
Print threaded layers @ 0.05mm.
Print non-threaded layers @ 0.2mm.
Time to Print:
Base = 5 hours
Lid = 2 hours
Doge donations: D5cqNG1nHCRWeyFHv5LaJNrMP54MVyM2Az
Much appreciated!
Fits 13 SD cards comfortably, not too loose, not too tight.
Fitment may differ depending on print setting and printer capabilities.
V2 has less thread, so about 4 twists compared to 8 twists to remove lid. Thread pitch hadn't changed though. (I haven't tested this yet)
Print threaded layers @ 0.05mm.
Print non-threaded layers @ 0.2mm.
Time to Print:
Base = 5 hours
Lid = 2 hours
Doge donations: D5cqNG1nHCRWeyFHv5LaJNrMP54MVyM2Az
Much appreciated!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
