Thingiverse
Sensor Community Case
von goodsam
2
Downloads
6
Likes
0
Makes
Hello,
I’ve just finished designing and printing an outer case, as I couldn’t find a suitable model.
I voluntarily left aside the NodeMCU ESP8266 which will remain warm and will be connected to the external box via a RJ-45 cable.
There are two shrinkages on the inside of the cover, one on the left and the other on the right, so that a mosquito net can be glued on.
The main Rj45 cable comes from the bottom of the box.
the DS011 Fine dust sensor is inserted on the right,
the BME280 6-PIN is positioned upper left.
I’ve just finished designing and printing an outer case, as I couldn’t find a suitable model.
I voluntarily left aside the NodeMCU ESP8266 which will remain warm and will be connected to the external box via a RJ-45 cable.
There are two shrinkages on the inside of the cover, one on the left and the other on the right, so that a mosquito net can be glued on.
The main Rj45 cable comes from the bottom of the box.
the DS011 Fine dust sensor is inserted on the right,
the BME280 6-PIN is positioned upper left.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
