Sensorcon CO detector Box

Box to store a Sensorcon Carbon Monoxide detector.
Fits snug, doesn't rattle. Box also has a spot for a spare battery.
The lid has a place to hold the manual.

The hinge uses a piece of 1.75mm filament as the pin.

Designed in fusion360.

This is Rev 1, but the box was designed to print without supports.
Unfortunately the lid needs supports when printed in any orientation. I would like to resolve this in the future.
Also looking into redesigning the lid to print the letters in an alternate color using Chep's z-hop trick.
But for now the print works great at keeping an expensive sensor protected. At least, better than the tiny cardboard box it came in.