SENTOR

Hi everyone, today I’m bringing you my work "SENTOR." Feel free to download and print it.

The entire assembly takes about 2 hours and doesn’t require screws or glue.

PLA is recommended for printing, as some parts are quite small, and PLA makes printing and assembly easier. You can freely experiment with color schemes.

A 0.3mm tolerance has been set for part gaps in the original design. Depending on your print results, you can use Blu-Tack to reinforce connections, though there shouldn’t be any issues with assembly.

Blu-Tack isn’t mandatory—you can assemble it without it.

For certain parts, a rubber mallet might be helpful. Refer to the assembly instructions for details.

"SENTOR" is my first attempt at designing a mech, representing a significant challenge. It holds special meaning for me. I hope to share this work with fellow mech enthusiasts, allowing everyone to experience the process from printing to assembly and enjoy the sense of accomplishment upon completion. It was this v