MakerWorld
Other Hobby & DIY
Model downloaden
Sequential shifter sim racing
47
Downloads
49
Likes
5
Makes
DIY shifter for simracing.Tools needed:Soldering iron + tinFlathead screwdriver2mm hex screwdriverSuperglue(jumper wires)Hardware needed:16 - M3x20 buttonhead screw16 - M3 brass insert2 - 626RS ball bearing2 - 6000RS ball bearing2 - M6 nut2 - 10x17 compression spring1 - 8x35 compression spring1 - 9x30 tension spring cut in half1 - M10 threaded rod cut to 55 mm length1 - M6 threaded rod cut to 70 mm length2 - microswitches - type does not matter1 - Arduino (Uno, Nano, Mega…)Some wire.The assembly process i pretty straight forward if looking at de photos. the bearings should be a slight press fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
