Thingiverse
Automotive
Zum Modell
Sequential Shifter
31
Downloads
37
Likes
1
Makes
This is a mini sequential shifter that I've designed and made for my sim racing rig. Please find the attached video for the overview. I have mainly used PETG and PLA for the build.
The following components have to be printed in multiple numbers:
1. Push connector x2
2. Inner spring holder x4
3. Connector half pins x4
4. Inter Locker x4 (as per your preference)
5. Side attachment x2
Please note that the side attachment and lower plate are for securing the arrangement to a table top.
A M4 x 50mm screw and nut, M5 x 35mm screw and nut (3 no.s) is required and several sets of M3 screw and nuts are required (approx.14).
Watch : https://www.youtube.com/watch?v=JtILAiM3eyM for the overview.
The following components have to be printed in multiple numbers:
1. Push connector x2
2. Inner spring holder x4
3. Connector half pins x4
4. Inter Locker x4 (as per your preference)
5. Side attachment x2
Please note that the side attachment and lower plate are for securing the arrangement to a table top.
A M4 x 50mm screw and nut, M5 x 35mm screw and nut (3 no.s) is required and several sets of M3 screw and nuts are required (approx.14).
Watch : https://www.youtube.com/watch?v=JtILAiM3eyM for the overview.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
