ShapeOko 2 Spindle Mount

This spindle mount is useful for attaching a chinese spindle to a ShapeOko 2 z-axis assembly. I use it for a 1,5kW aircooled 65mm spindle. Because of the size the mount needed to be a bit bigger to avoid a collision with the z-axis stepper motor mount.

The mount was printed with PLA plastic and 35% infill, but at a later stage I might exchange it with a milled aluminium version. The two M5 30mm screws that attach the mount to the z-axis plate need to be sunk into the PLA material. I used a micro blow torch to heat up just the screw top for a few seconds and press it into the PLA with a screwdriver.

Attached is also a sketchup file if you need to adjust anything for your own setup.

This mount is inspired by forgottenCNCs spindle holder:
http://www.shapeoko.com/forum/viewtopic.php?f=21&t=1108&start=20