Thingiverse
Shapeoko BitZero Probe Holder
door Descotti
37
Downloads
16
Likes
1
Makes
A simple holder for the Shapeoko BitZero probe.
Indentation on the left side is for a 12mm neodymium magnet to hold the clip.
Printed on fine setting with a 10% fill. No supports needed.
Indentation on the left side is for a 12mm neodymium magnet to hold the clip.
Printed on fine setting with a 10% fill. No supports needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
