Thingiverse
Shapeoko BitZero Probe Holder
von Descotti
37
Downloads
16
Likes
1
Makes
A simple holder for the Shapeoko BitZero probe.
Indentation on the left side is for a 12mm neodymium magnet to hold the clip.
Printed on fine setting with a 10% fill. No supports needed.
Indentation on the left side is for a 12mm neodymium magnet to hold the clip.
Printed on fine setting with a 10% fill. No supports needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
