Slicer Discord
Shotgun shell holder – Modelo 3D imprimible de MakerWorld MakerWorld
Sport & Outdoors

Shotgun shell holder

408 Descargas
532 Likes
91 Makes
Ver Modelo
Shotgun 12GA shell holder, 8rounds capacity.You need also8 magnets 8x2mm glued in upper part (i tried it without magnets on shooting range, and it was ok, but it is better to gle magnets to be sure that shells will be in proper place);4 bolts M5x70 with nutsspring 8x80 - i cutted it to about 2cm-3cm pieces I added new version of shell holder - there is more room for fingers! please check it, and rate after succesful prints
Categoría
Sport & Outdoors
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección