Showcase miniatures - elevated

After some research to find a nice 3D design that would showcase miniatures beautifully, I ended up with this design. However, without paying attention to the file provided by the original creator and after the first print, I noticed a couple of issues. Firstly, it was too small for 25mm miniatures, and secondly, it had a thin layer at the bottom (for some reason?) that prevented the rest of the structure from sitting flush on the surface. As a result, the back part would lift during printing.

In my modified version, you will find:

- 5 columns x 5 rows for 25mm miniatures
- 6 columns x 5 rows for 25mm miniatures
- The original 7 columns x 5 rows for 25mm miniatures
- A 4-row x 1-column version for 40mm miniatures
Feel free to reach out if you'd like help with any other combination.

Additionally, after some trial and error, I ended up using a Gyroid pattern with 9% infill density, which I found to be the optimal balance between material usage and providing a solid base for the miniat