Side Plexi Holder Quick Access

NOTE: THIS PART IS ONLY ONE SIDE. FROM YOU SLICER YOU WILL NEED TO USE THE MIRROR FEATURE TO GET OPPOSITE HAND PART.

This part is designed for the Duplicator 4s to allow for easy removal and placement of the side plexiglass. I have found that when printing PLA my full enclosure can get warm enough to negatively affect my prints.

By adding these holders it makes it so that it is a tool less operation to remove the side plexiglass if desired for a printing process, as well as making it easier to clean the inside of the enclosure.

I was able to reuse the factory hardware that was originally holding the plexi in place so no need to buy any hardware. New holes will need to be drilled to mount these. When marking the holes, leave the plexi bolted in place with the top two screws, hold the brackets firmly up against the glass, mark the hole positions, remove the plexi, drill, reuse factor bolts for new pieces, and slide the plexi back in place.

I would recommend removing the ent