Simchair MKIII basic 6 axis controller (outdated)

-----------------------
This one is no longer supported.
Use an I2C version:

https://www.thingiverse.com/thing:2919692

----------------------------------------

This is a Simchair MKIII 6 axis controller enclosure. The controller itself is an Arduino UNO (the one with atmega 16u2 on USB, e.g. original one or its exact clone) with a protoshield v 5 on top of it. A frame adaptor holds 4 8p8c sockets that are glued to it. The software for it is included (UnoJoy_10bit_3_axes_v1.1.zip). It allows up to 6 axes to be connected. It does not support buttons (i will design a separate button controller with a wireless interface to support interchangeable wireless collective heads, cyclic grips, overhead panels etc after I will be done with mark III cyclic and pedals)

You can also find the firmware on GitHub: https://github.com/hc625ma/simchair

You will need:
Arduino UNO (https://goo.gl/2dhz99) x 1pcs (note that atmega 16u2 on USB is a MUST)
Arduino UNO Proto shield (https://goo.