Simple cable holder

There are 2 STL files, one would be if you use conical head screws and the other on if you have flat head screws.

I was looking for a quick solution to hold some of my cables under the table, I was looking for a quick, simple and fast print. I didn't need a clip to hold the cables, I didn't need it to be tight, I just wanted to prevent them from hanging around. So I made this simple 20 minute print.

The big hole is for your screwdriver or drill to fit and the small one should be good for any screw thats laying around your house.

Size is 25mm in length, 15mm width and 20mm height.

25x15x20mm