Thingiverse
Simple Hot Wheels Track Connector
46
Downloads
22
Likes
1
Makes
Super simple connector for hot wheels track. It has the pegs for the little holes. We just flip it around if the pieces don't have the holes.
Just made it so I can build some pieces off of it. Suggestions welcome, there's not nearly enough hot wheels content on here!
It's a 20 minute print with ABS. Currently using 20% infill, it doesn't really matter as the only infill goes into the little pegs. The Base is solid as it's only 1.5mm thick.
Just made it so I can build some pieces off of it. Suggestions welcome, there's not nearly enough hot wheels content on here!
It's a 20 minute print with ABS. Currently using 20% infill, it doesn't really matter as the only infill goes into the little pegs. The Base is solid as it's only 1.5mm thick.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
