Simple loo roll holder

A simple loo roll holder to be mounted on the wall to hold different sized loo rolls.

Instead of large, material intensive versions, I have made this to be easily and quickly printed.

Measure the diameter of your regular loo rolls and choose either the 130mm version, or the 110mm version depending on the general size of your loo rolls. I would advise the 130mm version, unless your rolls are smaller than 110mm.

You will need 1 screw and rawlplug per pole. The easiest way to mark out, is to use the connector part as a stencil, using the centre holes to mark out the drill holes.
(BE CAREFUL: Do not drill without checking with a stud checker, especially in a bathroom, there may well be water pipes, electrical cabling, etc.)

For a 3 loo roll wide version, you need to print:
4x Pole
1x Connector
1x Connector_end 1
1x Connector_end Equal

For a 4 loo roll wide version, you need to print:
5x Pole
2x Connector
2x Connector_end 1

For a 5 loo roll wide version, you need t